Workrite Sonoma Series PREMIUM Assembly Instructions - Manual (Page 3)

1450 Technology Lane • Petaluma, CA 94954 • 800-959-9675 • www.workriteergo.com Page 3
1500068 • Rev. C
Sonoma Series
™
PREMIUM Workcenters
1450 Technology Lane • Petaluma, CA 94954 • 800-959-9675 • www.wrea.com Page 3
ASSEMBLY INSTRUCTIONS
Remove and discard Phillips
head transit screws from
sheet metal plates at both
ends of leg assembly.
Attach Top Bracket to
smallest end of each
leg assembly using
3/4” button head
machine screws.
This end is up and
attaches to the underside
of the worksurface.
Note: if table has three
legs, the center leg uses
the short Top Bracket.
Remove nuts and
lock washers from leg
studs. If 2-leg table, Slide
Stiffening Bracket onto
studs, slide Crossbar Bracket
onto studs and reinstall nuts
(no lock washers). Note how
the flange orients to the leg.
Note: if table has three
legs, the center leg uses
the double flange Crossbar
Bracket. The two Acorn nuts
should be used with this bracket.
Insert Foot Caps into
ends of foot. Screw in
Leveling Glides. Slide foot
onto Leg Assembly and
attach with button head
machine screws. Note that
the longest end of the foot
extends to the front
edge of the worksurface.
STEP 1
STEP 3
STEP 2
Place assembled legs onto the underside of the
worksurface in their approximate location. Note
that mounting holes have been pre-drilled to match
the top bracket.
STEP 4
OPEN ALL PACKAGES AND VERIFY THAT YOU HAVE ALL THE HARDWARE AS INDICATED IN THE PARTS LISTING.
To assemble you will need a #3 tip Philips screwdriver and a 7/16" wrench or socket.
Note: if table has three
legs, the center leg uses
the short Foot.
Left Leg
Right Leg
Fron
t
Fro
nt
Fro
nt
Stiffening Bracket
(2-Leg tables only)