Workrite Series VALUE Assembly Instructions for Tables with Right Front Crank - Manual (Page 8)

8 Workrite Ergonomics | 800.959.9675 www.workriteergo.com
Sonoma Series™ VALUE Workcenters - Assembly Instructions for Tables with Right Front Crank
a
b
c
Attach and Connect Right Leg (Leg 1) and Crank Handle
Attach Crank Handle Assembly to Crank Tube, using
Crank Handle Hex Shaft. Insert short end into leg and
long end through Crank Handle Assembly and into
Crank Tube.
Slide Crossbar over Leg Bracket on Leg 1 and secure
using two Lock Washers and Button head Machine
Screws.
For base-only version, proceed to step 11.
Attach top plate of Leg 1 to desk using 10 Wood
Screws provided. Use locating holes. If you use an
electric screwdriver, be sure it is on the lowest torque
setting to avoid stripping the threads.
Attach Crank Handle Assembly to desk using remain-
ing 6 Wood Screws, but do not tighten them at this
point.
Gently pull out the handle and test that it will clear the
table so that it can be rotated.
If you have a Workrite Tabletop, proceed to
step 12.
d
S
T
N
H
G
B
R
Leg 1
V
V
V
a
b
c
d
10
9
a
b
c
Attach Left Leg to Crank Tube, Crossbar and Table
Use second Side Entry Hex Shaft to connect Left Leg to Crank
Tube, inserting short end of shaft into leg and long end into
Crank Tube.
Slide Crossbar over Crossbar Bracket on Left Leg
and secure using two Lock Washers and
Button head Machine Screws.
For base-only version, proceed to step
10.
Attach top plate of Leg to desk using 10 Wood
Screws provided. Use the locating holes. If you
use an electric screwdriver, be sure it is on the
lowest torque setting to avoid stripping the
threads.
a
b
c
M
H
G
Left Leg
S
T V
A
Note that the Stiffener
Bracket shown between
the leg and the Crossbar
Bracket applies only to
2-Leg Tables.