Workrite Series VALUE Assembly Instructions for Tables with Right Front Crank - Manual (Page 7)

Workrite Ergonomics | 800.959.9675 www.workriteergo.com 7
Sonoma Series™ VALUE Workcenters - Assembly Instructions for Tables with Right Front Crank
7
a
b
c
a
b
c S
T
M
O
H
G
Be sure to use the
correct hex shaft inserted
in the proper orientation or
the table will not function.
For 3-Leg Tables: Attach Crank Tubes and Crossbars to Leg 2
Use Front Entry Hex Shaft to connect Crank Tube to gear mechanism in
side of leg pointing to Leg 3 (left leg).
Use Side Entry Hex Shaft to
connect Crank Tube to gear
mechanism in other side of
leg 2. See diagram for correct
placement and orientation.
Slide Crossbars over Leg
Brackets on Leg 2 and secure
using two Lock Washers and
Button head Machine Screws
for each Crossbar.
For 3-Leg Tables, proceed to step 9.
c
Leg 1
8
Leg 3
For 2-Leg Tables: Attach Stiffener and Crossbar Brackets to Legs
(repeat for both legs)
Turn legs upside down.
Remove nuts and lock washers from leg studs.
Slide Stiffener Bracket onto studs with concave side facing
the leg.
Slide Crossbar Brackets onto studs and reinstall nuts (but
not lock washers). Note how the flange orients to the leg.
a
b
c
a
b
c
P
W
B or C