Workrite Sierra HX Pin Assembly Instructions for 3-Leg Pin models - Manual (Page 3)

Workrite Ergonomics | 800.959.9675 www.workriteergo.com 3
Workrite Sierra HX™ 2-Leg Front-Crank Workcenters - Assembly Instructions
d
To avoid stripping the threads,
always insert and make the
first few turns of the screw BY
HAND with an Allen wrench,
ensuring it is in straight.
a
c
d
b
24" deep or less more than 24" deep
With legs on their sides, pin side down, attach a Long Brace (B) to top of each Side Leg (D) using
Machine Screws (G). The Braces should have the lips on top, facing away from the legs. Do not
tighten screws completely.
b
2
Assemble Legs
Attach one Leg Cap (F) to the top of Center Leg (J) and each Side Leg (D) using Machine Screws
(G). Do not tighten screws completely. Be sure Leg Caps face each other.
a
Turn Leg Assembly upside down and attach all four Short Braces (C) using Machine Screws (G). Do
not tighten screws completely.
c
Attach Side Braces (E) to sides of Side Legs and back of Center Leg using Machine Screws (G). If
you have a 24” deep or less worksurface, use the holes towards the back of the brace so that the
brace extends out above the long part of the foot. For deeper worksurfaces, use the center holes of
the brace so that it is centered on the leg. Do not tighten screws completely.
d
c
c
c
d
d
D
F
G
B
I
F
G
I
C G
E
I
G
E