Cambridge Audio 840A - Manual (Page 10)

10 Azur Class XD integrated amplifier
The 840A is supplied with an Azur Navigator remote control that
operates both this amplifier and Cambridge Audio Azur CD
players. Insert the supplied AAA batteries to activate.
The 840A/C remote control comes with an Amplifier
Control button, that when pressed, puts the remote into
Amp mode, allowing operation of the 840A. When
pressed, the LED will light up for 7 seconds (to let you
know you are in Amp mode), and will then flash when one
of the circled Amp buttons is pressed. All other remote
buttons are inactive when in Amp mode.
The functions relevant to the amplifier are as follows:
Standby/On
Switches the amplifier between On and Standby mode.
Numerical buttons 1-8 8
Press to change the input source to the amplifier. Button 8
toggles Tape Monitor on/off.
Mode
Press to switch between Volume and Balance modes.
REMOTE CONTROL
Mute
Mutes the audio on the amplifier. The mute mode is indicated by
MUTE appearing and the volume level being replaced by two
flashing dashes in the display. Press again to cancel mute.
Volume
Increase or decrease the volume of the amplifier output.
Speaker A/B
Press to scroll through the speaker sets connected to the
loudspeaker terminals on the back panel (speaker sets A, B or A
and B).
Bright
Adjust the backlight of the front panel display; bright, dim or off.
To exit Amp mode (and return to CD mode), press the Amp Control
button again (the LED will light up for one second).
Vol
Vol
Random
Repeat
Select
Remain A - B
Menu
Space
Speaker
A/B
Intro
Mode
Prog
Amp
Control
Mode
Speaker
A/B