Removing a module, Figure 2-13 – Cisco 3130 User Manual

Page 44

2-24

Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Hardware Installation Guide

OL-13269-01

Chapter 2 Switch Installation

Installing Devices in the 10-Gigabit Ethernet Slots

Figure 2-13

Installing Converter Modules

Removing a Module

To remove an X2 transceiver module or a converter module, follow these steps:

Step 1

Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface.

Step 2

For X2 transceiver modules, disconnect the cables from the module. For fiber-optic modules, install the
optical bore dust plugs.

Step 3

For converter modules, disconnect the cables from the SFP module. Remove the SFP modules from the
converter module.

Caution

Do not remove the converter module with SFP modules or cables installed. Always remove any cables
and modules before removing the converter module from the slot.

Step 4

Carefully pull on the X2 module sleeve, or pinch the tabs on the converter module to disengage it from
the slot. Grasp the edges of the module, and carefully slide it out of the slot.

Step 5

Reinstall the dust cover in the 10-Gigabit Ethernet slot.

Caution

The dust covers should always remain in place unless a module is installed in the slot.

Step 6

Place the module in an antistatic bag or other protective environment.

250288

STK

17X

18X

19X

20X

X2-1

X2-2