Operations, Basic operations, Caution – Clarion DMX5555Z User Manual

Page 5

280 7323 00

DMX5555z

6. OPERATIONS

Basic Operations

Note: Be sure to read this chapter referring to the front diagrams of

chapter “3. CONTROLS” on page 5 (unfold).

CAUTION

Be sure to lower the volume before switching
off the unit power or the ignition key. The unit
remembers its last volume setting. If you
switch the power off with the volume up, when
you switch the power back on, the sudden
loud volume may hurt your hearing and dam-
age the unit.

The clock is displayed when the ignition key
is turned to the ACC (accessory) or IGN (igni-
tion-on) position even when the unit power
is off. In some cars, the clock may momen-
tarily disappear when the ignition key is
turned to the START position. The clock will
reappear after the engine has started and the
ignition key is released to the IGN (ignition-
on) position.

Turning on/off the power

Notes:
• Be careful about using this unit for a long time with-

out running the engine. If you drain the car’s bat-
tery too far, you may not be able to start the en-
gine and this can reduce the service life of the
battery.

• System check

This unit checks what external equipment is con-
nected to the CeNET. The first time the ACC/Igni-
tion is turned on (initialization), “SYSTEM” and
“Push PWR” alternately blink in the display. Press
POWER button

to start the system check. When

complete, press POWER button

again to acti-

vate the unit.

1. Press POWER button

2. The illumination and display on the unit light

up. The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.

3. Press and hold POWER button

for 1 sec-

ond or longer to turn off the power for the unit.

Selecting a mode

1. Press FUNC button

to change the mode

of operation.

2. Each time you press FUNC button

, the

mode of operation changes in the following
order:

Radio mode

➜

CD mode

➜

MD mode

➜

changer mode

➜

MD changer mode

➜

mode

➜

Radio mode...

∗

External equipment not connected with CeNET
is not displayed.

Adjusting the volume

Press Up button

or Down button

increases

or decreases the volume.

∗

The volume level is from 0 (minimum) to 33 (maxi-
mum).

Switching the display

Press DISP button

to select the desired dis-

play.
Each time you press DISP button

, the display

switches in the following order:

Main display

Sub (title) display

Clock display

Main display...