Vinten Radamec Virtual Reality interface (VRi) - Manual (Page 18)

16
Troubleshooting
Fault Check Comments
VRi box is switched on, but
mains, 5V and 12V power
indicator LEDs are not
illuminated. Check that either a 50–60 Hz AC mains power supply of 100–
240V or a DC power supply of 9.5–28V is connected.
If DC output from the VRi box is in use, try disconnecting it in
case the load is too high
If a mains supply is connected to the VRi box, check and/or
replace the fuse.
Genlock indicator LED is red. Check that the genlock signal from the studio supply is con-
nected to the Genlock In BNC connector.
If using a camera as a genlock source, the output must be
configured to genlock black. If the problem persists, contact Vinten or
Vinten Radamec customer support.