Vinten Radamec SE-500 Elevation Unit User Manual
Page 24
23
1.
Connect the ELEVATION connector on the control box to the connector at the top of the
telescopic column using cable AM056-9001.
2.
Tighten the cable clamp
Fig 2.3 A typical SE-500 installation
Connect From
Cable Type
Connect To
Control system/power supply
SP-CAB-xx(M)
PWR/DATA IN on control box
PWR/DATA OUT on control
box
SP-CAB-8
PWR/DATA on pan and tilt head
ELEVATION on control box
AM056-9001
Connector on telescopic column
NOTE: In the figure and table above, ‘xx’ denotes the cable length in feet, ‘xx(M)’ the length in metres.
See also other documents in the category Vinten Radamec Equipment:
- 435H Pan & Tilt Head (10 pages)
- AutoCam Multicontroller II (62 pages)
- Ci Box ICE Interface (20 pages)
- e-Series Interface (7 pages)
- FHR-35 (36 pages)
- Free-d (46 pages)
- Fusion APS (28 pages)
- Fusion Camera Control Unit (CCU) (20 pages)
- Fusion CP4 (36 pages)
- Fusion FBH-175 (24 pages)
- Fusion FCS-16 (40 pages)
- Fusion FH-100 (38 pages)
- Fusion FH-200 (24 pages)
- Fusion FHR-100VR (44 pages)
- Fusion FHR-120 (40 pages)
- Fusion FHR-145 (24 pages)
- Fusion FP-145 (30 pages)
- Fusion FPH-188 (38 pages)
- Fusion FPR-210 (36 pages)
- Fusion Virtual Reality box (FVR) (20 pages)
- Head Processing Module (HPM) (20 pages)
- HS-102PE Pan & Tilt Head (30 pages)
- HS-105PE Pan & Tilt Head (28 pages)
- HS-2010MED Pan & Tilt Head (70 pages)
- ICE Tool (24 pages)
- Legislative Control System (34 pages)
- Native Lens Drive (NLD) (19 pages)
- Quattro SE HPM (23 pages)
- Quattro SE PDA (36 pages)
- Quattro SE Pedestal (30 pages)
- SP-2000 Pedestal (106 pages)
- Control (VRC) (100 pages)
- HDVRC (70 pages)
- Virtual Reality interface (VRi) (24 pages)
- Vision 250E (18 pages)