Introduction, Tools you will need – Vinten Radamec SE-500 Elevation Unit User Manual
Page 21
20
Introduction
This chapter focuses on the mechanical aspects of unpacking and assembling the servo elevation unit and
mounting a pan and tilt head.
Tools you will need
You will need the following tools to assemble the servo elevation unit and mount the pan and tilt head
1.
A set of hex wrenches (metric and US sizes)
WARNING!:TO PREVENT PERSONAL INJURY, AND FOR PROPER PERFORM-
ANCE OF THE EQUIPMENT IT IS ESSENTIAL THAT THE PROCEDURES IN THIS
MANUAL ARE FOLLOWED EXACTLY.
Fig 2.1 Assembling the elevation unit
(3)
(6)
(3.1)
(6.1)
(6.2)
(6.3)
See also other documents in the category Vinten Radamec Equipment:
- 435H Pan & Tilt Head (10 pages)
- AutoCam Multicontroller II (62 pages)
- Ci Box ICE Interface (20 pages)
- e-Series Interface (7 pages)
- FHR-35 (36 pages)
- Free-d (46 pages)
- Fusion APS (28 pages)
- Fusion Camera Control Unit (CCU) (20 pages)
- Fusion CP4 (36 pages)
- Fusion FBH-175 (24 pages)
- Fusion FCS-16 (40 pages)
- Fusion FH-100 (38 pages)
- Fusion FH-200 (24 pages)
- Fusion FHR-100VR (44 pages)
- Fusion FHR-120 (40 pages)
- Fusion FHR-145 (24 pages)
- Fusion FP-145 (30 pages)
- Fusion FPH-188 (38 pages)
- Fusion FPR-210 (36 pages)
- Fusion Virtual Reality box (FVR) (20 pages)
- Head Processing Module (HPM) (20 pages)
- HS-102PE Pan & Tilt Head (30 pages)
- HS-105PE Pan & Tilt Head (28 pages)
- HS-2010MED Pan & Tilt Head (70 pages)
- ICE Tool (24 pages)
- Legislative Control System (34 pages)
- Native Lens Drive (NLD) (19 pages)
- Quattro SE HPM (23 pages)
- Quattro SE PDA (36 pages)
- Quattro SE Pedestal (30 pages)
- SP-2000 Pedestal (106 pages)
- Control (VRC) (100 pages)
- HDVRC (70 pages)
- Virtual Reality interface (VRi) (24 pages)
- Vision 250E (18 pages)