Vinten Radamec Fusion Virtual Reality box (FVR) - Manual (Page 11)

9
Installation
On completion, mount the head back on to its support, together with the
camera and other accessories. Re-check the balance of the head and
adjust as required.
Power Options
Fitting the FH-100 VR PSU to the FVR box
When fitting the FVR box to an FH-100 VR pan and tilt head, the PSU
(part no. V3851-1031) must be mounted underneath the FVR box. To
mount the PSU, proceed as follows:
1. Remove the plastic blanking plug [6] from underneath the FVR
box.
2. Mount the PSU to the base of the FVR box using the brackets and
screws provided.
8
VR data VR data
3
FHR-120 VR
FH-100 VR
CAUTION! Using alternative power sources will invalidate
the system EMC liability.
HEAD POWER
SOURCE
POWER
CONTROL
DC
OUTPUT
FH-100 VR
AC power via
FVR PSU
Power on/off
switch on the
FVR box
Enabled
FHR-120 VR
DC power from
the head via
the VR
interface cable
Power on/off
switch on the
head
Not
available