Vinten Radamec Fusion FH-145 - Manual (Page 13)

FH/FHR-145 Pan and Tilt Head
Mounting the Camera
1.
2.
Apply the tilt lock. Using a
5 mm Allen key, remove
the three centre screws
securing the camera
cradle and set the
camera cradle to its
lowest position.
Secure the cradle in
position. Adjust the
jacking screw as required
to level the horizon.
3. Carefully position the
camera onto the cradle.
Align the mounting holes
in the bottom of the
camera with one of the
slots on the cradle. Fit
the camera screws and
tighten to secure the
camera in position.
Installation Guide
Installation
Using a 5 mm Allen key, tighten the jacking screw underneath
the mounting plate to adjust the horizon level of the payload.
Loosen the jacking screw before adjusting the height of the
mounting plate.
Adjusting the Horizon Level
11