Vintage Cellars Monterey ETL 12-bottle - Manual (Page 3)

3
Unpacking
While unpacking your unit, please check to make sure that all parts are included and undamaged. Please
call WineKeeper at 855.511.5113 if there are any problems. YOU MUST REPORT damage immediately
and missing parts within 7 days of receiving your unit.
These parts are included with your unit:
• Appropriate number of faucets for your unit
• Regulator (for use with refillable nitrogen or argon cylinder)
• Cleaning kit
• Ventilation screens
• Instructions
Setting Up Your Unit
Your WineKeeper wine dispensing unit must be installed on a flat, level surface with vented space of at
least 3" behind, 1" on the sides, and 12" above the unit for proper ventilation. Remove the temporary
glides/feet and seal unit to the counter top. Once your unit is properly located, attach the faucets. Taking
care to align the threads properly, place the faucet
on the thru-wall and tighten the wing nut.
You may now plug the units’ power cord into
110 volt grounded electrical outlets.
• 4-bottle units = 1 plug
• 8-bottle units = 2 plugs
• 12-bottle units = 3 plugs
An 8 foot gas supply line is included with your
unit. The supply line includes a quick connect
fitting that connects to the regulator supplied
with your unit. USING A REGULATOR
OTHER THAN THE ONE SUPPLIED WILL
VOID THE WARRANTY. Your nitrogen/argon
cylinder can be placed anywhere convenient—
vertical or horizontal.
DO NOT TAMPER
WITH OR REMOVE THE
QUICK-DISCONNECT TO
COUPLE YOUR GAS SUPPLY
LINE AND REGULATOR,
THIS WILL ALSO VOID
THE WARRANTY.