Vintage Cellars Le Cache Setup Instructions - Manual (Page 5)

L E C A C H E P R E M I U M W I N E C A B I N E T S
-13-
CREDENZA WINE CABINETS –
CREDENZA TOP AND BASE MOLDINGS
For European Country and Mission credenzas, the moldings are shipped in a separate box.
To attach the moldings, do the following:
- Adjust the leveling feet below the credenza until the doors are aligned
- Align the sides of the base molding with the tracks on the bottom of the wine
cabinet, and gently slide the molding back until it comes to a stop.
o It may be necessary to tilt up the front of the wine cabinet in order to install
the base molding.
o If the base molding won’t slide into place, you may need to extend all the
leveling feet an equal amount to raise the wine cabinet while maintaining the
alignment of the doors.
- Remove the credenza top and place it on the top of the credenza. The holes in the
top should be aligned with the holes in the credenza
- Place a washer on each bolt, and from inside the credenza, insert the bolts through
the holes in the ceiling of the credenza, and fasten the bolts to the credenza top.
DO NOT OVERTIGHTEN.