VintageView WSBIG1 - Big Bottle Rack - Manual

WS-BIG1 contains:
WS-BIG1 Wall Mount
Wine Rack Instructions
Wine Master Cellars •10645 E 47th Ave, Denver, CO 80239 • phone: 866.650.1500 • fax: 866.650.1501
Please feel free to contact us regarding the assembly of this product.
Tools Needed:
Before starting, open all Packaging for the WS-BIG1 and take inventory to make sure you have everything.
• 1 Neck Strip
• 2 Plastic Couplers
• 1 Spirit Level
• 1 Marking Pen or Pencil
• 1 Tape Measure
• 1 Screwdriver
• Drill and Drill Bits (Necessary in Some Cases)
There are four pre-drilled mounting holes in each strip, eight total, per rack. Appropriate fasteners must be utilized in
every mounting hole for proper installation. Fasteners are not included with your WS-BIG1. However, we recommend the
following fasteners for these surfaces:
Fasteners:
• Wood Surface: #8 x 1-1/4” wood screw
• Drywall/Wallboard Surface: #8 x 1-1/4” screw with spiral inserts for the bottom two holes in each strip (4 total) and
an expanding hollow wall anchor such as a toggle bolt for the top hole in each strip (2 total)
• Concrete, Brick or Stucco: 3/16” x 1 ¾” masonry screw or #8 x 1 ¼” screw with appropriate size expanding anchor
NOTE: If you are attaching the WS-BIG1 to a custom Floor to Ceiling Frame (FCF) you will attach the units to the
FCF using the self-drilling screws included in the FCF packaging.
WS-BIG1 Installation Instructions
1 - Determine which direction the bottle necks
should point.
• 1 Base Strip • 8 Rubber Mounting Hole Caps
1.1. If the bottle necks are to point to the right, the base
strip must be installed to the left of the neck strip.
1.2. If the bottle necks are to point to the left, the base
strip must be installed to the right of the neck strip.
2.1. The centerline of the first strip (either base or neck
depending on bottle neck direction) should be at least 3
½” from adjacent walls or obstructions. This allows for the
bottle to overhang the rack (Fig. 1, Dim. A).
2.2. From centerline of the first strip, measure 10-14” to
the centerline of the next strip. This dimension should be
tailored to the specific bottle size (3L to 6L) that will be
stored in the rack (Fig. 1, Dim. B).
2.3. (For multiple columns) Locate the centerline of the
next strip (Fig. 1, Dim. C) twice the measurement used for
Dim. A, approximately 7”, away from the prior strip. [Dim.
A X 2 = Dim. C]
2.4. (For multiple columns) Continue marking the center-
lines, alternating between Dim. B and Dim. C.
2 - Lay out the wall.
DIM. A
DIM
. B
DIM
. B
D
IM
.C