Vetter Oil water debris aspirator - Manual (Page 25)

Page 9/13
Chemical resistance list Products made of fibreglass-reinforced polyester
Vetter GmbH
A Unit of IDEX Corporation
Blatzheimer Str. 10 - 12
D-53909 Zülpich
Germany
Tel.: +49 (0) 22 52 / 30 08-0
Fax: +49 (0) 22 52 / 30 08-590
Mail: [email protected]
www.vetter.de
Medium GRP
Methylpyrrolidone D
Milk A
Mineral oil A
Mineral oil A
Mipolan mass 5319
Mirbane oil
Molub Alloy 601
Molub Alloy 602
Molub Alloy 603
Molykote A
(Mono)chlorobenzene C
Monoethanolamine
Motor (engine) oils A
Motor oil 20W/20 A
Motor oil 30 A
Motor oil W 10 A
Mustard A
Nafic H 402
Nafic H 404
Naphtha
Naphthalene
Naptolen ZD
Natural gas A
Nickel Chloride A
Nickel salts A
Nickel sulphate A
Nitric acid, diluted B
Nitrobenzene (mirbane oil) C
Nuto 022 H
Nuto H 36
Nuto H 44
Nyvac no. 20 A
Ocean water, 5% A
O-chloronaphthalene C
Oel-Sythesco CH 33
Oleic acid A
Olesimon 803
The information is based on laboratory examinations,
empirical values and is influenced by variable factors
such as the temperature, intensity and the contact
time. Exposure time 7 days
This resistance list was compiled based on the above
aspects. The information corresponds to today‘s state
of our knowledge and should be taken as typical va-
lues.
Chemical resistance
A High resistance
B Resistant
C Limited resistance
D Unstable or highly emollient
Not tested
Experiences are available on the following media (each at room temperature unless stated otherwise):