Vetter Oil water debris aspirator - Manual (Page 15)

Page 1/2
Chemical resistance list Suction hose
Vetter GmbH
A Unit of IDEX Corporation
Blatzheimer Str. 10 - 12
D-53909 Zülpich
Germany
Tel.: +49 (0) 22 52 / 30 08-0
Fax: +49 (0) 22 52 / 30 08-590
Mail: [email protected]
www.vetter.de
Medium PP
Acetic acid, 1% +
Acetophenone u
Acetyl chloride u
Acid sodium carbonate +
Ammonium hydroxide, 10 % +/-
Ammonium nitrate saturated solution +
Ammonium phosphate +
Aniline u
Anti-free additive +
Benzaldehyde u
Benzyl chloride u
Beverages, also alcoholic +
Butyl acetate u
Calcium acetate u
Calcium hydroxide u
Carbon tetrachloride u
Chromium acid u
Cleaning agent, high conc., up to 45 °C -
Cleaning agent, normal conc. up to 25 °C (soap solution, P-3 alkali, dishwasher agents, etc.) +
Cyclohexane, cyclohexanone, cyclohexanol u
Detergent for textiles, normal leaching concentrations +
Dichlorethane, dichloromethane u
Diesel fuel +
Diethylenglycol, 50% +/-
Dioxane u
Dishwasher agent, normal conc. +
Ethanol +
Ethyl acetate u
Ethylene glycol +
Formaldehyde, 20% +/-
Formic acid, 30 % u
Glycerine +
Glycol +
Greases and oils, acid-free from natural and mineral oil basis +
Heating oil, EL +
Heptane u
Hydrochloric acid, 0.5% - 1% u
The information is based on laboratory examinations,
empirical values and is influenced by variable factors
such as the temperature, intensity and the contact
time.
This resistance list was compiled based on the above
aspects. The information corresponds to today‘s state
of our knowledge and should be taken as typical va-
lues.
Chemical resistance
+ Resistant, no corrosion is expected
+/-
Slight effect of the medium is to be expected, but
still commercially tenable
-
Cannot be used permanently, occasional use pos-
sible
u Unstable, use is not recommended
Experiences available on the following media (each at room temperature):