Universal Remote Control (URS) TRF-ZW1 7.9.14 User Manual

Page 5

7. Connect the TRF-ZW1 back to the network and power cables

then login to the TRF-ZW1 programming software. You will find
the items add to the “No Rooms” section.

– (un-pairing button): After the TRF-ZW1’s battery mode is
activated and the ready light is flashing for pairing (include) you
will press the [-] on the unit. When the [-] button is pressed the
ready light will flash slightly faster in un-pairing (exclude) mode,
then in pairing (include) mode).

1. Go to the device you wish to un-pair (exclude) from the system

and perform the devices instructed in the un-pairing method.

2. The Ready light will quickly flash for 2 seconds to verify the

item has been un-paired (excluded).

3. When you are done un-pairing devices press the [-] to save the

changes.
● The Ready light will pause from flashing for a moment to

confirm.

4. To turn off battery mode press and hold the [+] for 5 seconds.
5. Connect the TRF-ZW1 back to the network and power cables

then login to the TRF-ZW1 programming software. You will find
the items removed are no longer in the program.

Reset button: WARNING!!! Pressing this button will set the unit
back to factory settings. Press and hold the recessed button adjacent
to the (-) unpair button for 10 seconds until the lights turn off.

TRF-ZW1 E

XTENDER