Trf-zw1 top panel descriptions – Universal Remote Control (URS) TRF-ZW1 7.9.14 User Manual
Page 4
2
TRF-ZW1 E
XTENDER
TRF-ZW1 Top Panel Descriptions
Power LED: Illuminates to indicate the TRF-ZW1 is powered.
Ready: Illuminates to indicate it is ready to receive data.
Network: Illuminates to indicate communication to the home network.
Error: Please consult the troubleshooting section of the URC MIOS
documentation site.
Battery button: This button is used to enter battery pairing mode
while pairing devices in various locations.
1. Disconnect the TRF-ZW1 from the network and power cable.
2. Insert 4 AA batteries into the bottom of the unit.
3. Press and Hold the “Battery” icon on the top of the unit for 5 seconds.
● The Power light will start to flash Blue for 30 seconds.
● After 10 more seconds the ready light will start to flash amber. By
default the unit goes into Pairing (Include) mode automatically.
+ (pairing button): Stated above the TRF-ZW1 defaults to Pairing
(Include) when battery power is activated.
1. The Ready light will slowly flash to show it is ready to pair a device.
2. Go to the device you wish to pair and perform its instructed
pairing method.
3. The ready light will quickly start flashing for 2 seconds to verify
the device has been paired.
4. You can continue to pair devices while in pairing mode.
5. When you are done pairing (including) devices press the [+]
button to save.
● The Ready light will not flash for a moment while saving.
6. To turn off Battery mode press and hold the [+] button for 5 seconds.