Torbal WM - Manual (Page 5)

- 4 -
1. Remove the Bluetooth module, antenna, Bluetooth PC dongle, RS232 crossover cable, and power supply
out of the package.
2. Connect the RS232 crossover cable’s end marked “Bluetooth” to the Bluetooth module and firmly tighten
the side relief screws in order to secure the RS232 cable with the Bluetooth module.
3. Connect the Bluetooth antenna to the Bluetooth module by screwing it into the antenna port. (Do not over
tighten).
4. Connect the adapter to the RS232 port located on your scale. Using a small flat head screwdriver secure the
RS232 cable by tightening the side relief screws.
Chapter 3: Unpacking and getting started