Clarion UNGO MS5500 - Manual (Page 17)

MS5500 Installation Manual - Page 13
The Mode Button will change the function of Buttons 1 and 2 each time it is pressed, allowing
Buttons 1 and 2 to control the system’s Auxiliary Function Outputs.
Note also that the LED on the transmitter changes color each time the Mode Button is pressed
to indicate the current function of Buttons 1 and 2. The LED will stay on for 5 seconds, then turn
off, returning Buttons 1 and 2 to their off settings.
It is also possible to set individual Remote Transmitters to arm and disarm the system using any
of the Transmitter’s function buttons, which is extremely useful when a Transmitter is used to
control multiple systems. See Adding a New Transmitter into the System.
The button assignment of Arming and Disarming will not affect the operation of the Remote
during Programming, Logic Sensor II Adjustment, or any other system set-up function. The
buttons used to control those features will remain as they are described in this manual,
regardless of how the Transmitter is set up to arm and disarm the system.
Convenience Mode
This mode will configure the system to Arm and Disarm on separate buttons for convenience
and ease of use.
Button 1 Arms the system. This Button also locks the doors when the system is in Valet Mode.
Button 2 Disarms the system. Pressing Button 2 again activates the system’s Auxiliary Function
1. This Button also unlocks the doors when the system is in Valet Mode.
If the system is Armed, pressing Button 2 will Disarm the system.
If the system is Disarmed, pressing Button 2 will activate the Auxiliary Function 1.
If the system is in Valet and the doors are locked, pressing Button 2 will unlock the doors.
Driver Door Priority Mode
This mode operates in a similar manner as the Convenience Mode, with the added safety of
unlocking just the driver’s door when the system is disarmed. Pressing the Disarm button again
within 10 seconds will unlock the remaining doors.
To properly utilize this mode, the Auxiliary Function 1 output must be connected directly to a relay
that controls the driver ‘s door lock actuator. See Driver Door Priority Wiring Diagrams
ARM
DISARM / AUX 1*
AUX 2
MODE
green
MODE
none
MODE
orange
not used not used not used
not used not used
MODE
red
BUTTON 1
BUTTON 2
MODE BUTTON
Mode Sequence
None:Green:Orange:Red:None:...
*AUX 1 when system is Disarmed
installation_MS5500.qxd 12/6/99 11:59 AM Page 13