Clarion UNGO MS5500 - Manual (Page 13)

MS5500 Installation Manual - Page 9
Pin 14 - YELLOW/white: Auxiliary Function 1 negative output
Provides negative (-) output. Output will stay on for as long as the Button is pressed.
4-Pin Auxiliary Function Harness
Pin 1 - YELLOW/black: Auxiliary Function 2 (-) output (resets with arm and disarm).
Provides a negative output to activate a relay. The output of this wire can be programmed
to operate in one of three operating modes. See Programming.
Momentary
- provides output for as long as the transmitter button is pressed.
Latched - provides an output that stays active until the transmitter button is
pressed again.
Timed - provides an output that stays active for 30 seconds when the
transmitter button is pressed. If the transmitter button is pressed
again during the 30 seconds, the output will turn off.
Possible uses of the latched and timed outputs include: audio system valet, auxiliary lighting
control, timed headlight operation, etc.
When latched or timed operation is selected, the output will reset (turn off) each time the
system is armed or disarmed.
Pin 2 - ORANGE/blue: Alarming / Horn Honk (-) output
Provides a negative output when the system is triggered to activate a relay. The output is
selectable for continuous or pulsed operation. See Jumper Settings.
This wire can be connected to a relay to honk the vehicle’s horn, or activate an auxiliary
siren or air horns when the system is triggered.
Pin 3 - BLACK/white: Dome Light (+/-) output [on-board relay, 5A Fuse]
Illuminated Entry/Exit output. Provides a selectable positive (+12v) or negative (-) output to
turn on the vehicle’s dome light when the system is disarmed and when the ignition key is
turned off. Normally, this wire can be connected directly to the door switch circuit. Be sure
to set the polarity of this output. See Jumper Settings.
Pin 4 - VIOLET/ yellow: Warn Away (-) input.
Connect to the negative Warn Away output from an optional sensor.
Other Harnesses
For details on the Status LED and Override Switch, see Mounting Components.
Extra LEDs
Up to 3 extra LEDs can be added. Cut the Red LED wire and connect in series as shown.
LED
Connector
installation_MS5500.qxd 12/6/99 11:59 AM Page 9