SINGER STEAMWORKS PRO - Manual (Page 4)

6 7
wARNINg: ALWAyS TURN OFF THE STEAMER BEFORE ATTACHING
ACCESSORIES TO AVOID INjURy.
Folding Hanger Assembly
Secure the Steam Head Hanger assembly to the Telescopic Pole. •
Tilt the hook of the Rotating Hanger and insert it into the hole on the flat side •
of the Steam Head Hanger. Press gently to lock.
Pull the arm of the Rotating Hanger up until the sides are completely extended. •
Lock the horizontal bar in place by aligning the dots on the bar. •
Filling the Water Tank
Turn the steamer off and unplug it. •
Remove the Water Tank by pulling upward on the handle. •
Unscrew the Valve Cap from the Water Tank, fill the tank with cool water, •
and replace the Valve Cap. Do not use hot water. To prolong the life of your
steamer we recommend using distilled or de-mineralized water.
The tank holds 2.5 Liters of water. •
Insert the Water Tank into the base, making sure the plug on the bottom of •
the tank meets the post on the steamer base and fits securely in the cavity.
NOTE: Do not operate the steamer without water as this could cause damage
to the unit.
Never use water with additives, including scents, starches, or fabric conditioners,
as they can cause deposits to form in the steamer that can stain your clothing.
Garment Clips Assembly and Use
Snap the Garment Clips into the holes on the horizontal bar of the Folding Hanger. •
Clip the Garment Clip Bar to the bottom of the Telescopic Pole. •
To use, hang the garment from the top clips and secure with the bottom clips, •
pulling the garment taut to steam or crease.
5738-SVP_InstructionSWP3.indd 6-7 4/21/10 4:18:56 PM