SINGER STEAMWORKS PRO - Manual (Page 3)

4 5
ASSEMblY
Assembling Your Steamer
Remove all packaging. •
Place the steamer base on the floor and remove the Water Tank. •
Insert the Telescopic Pole into the Pole Base and twist the ring clockwise to lock. •
Connect the Clothes Hanger Hook to the top of the Telescopic Pole as shown. •
Expand the Telescopic Pole by unlocking the clips and fully extending the •
pole. Lock clips to secure.
Attach the Cool Touch Hose by pushing the hose onto the Hose Base and •
turning 1/4 turn clockwise to lock.
Hang the Steam Head on the Steam Head Hanger. •
Crease Attachment Assembly and Use
Turn the steamer off and wait until there is no steam coming from the Steam •
Head. And it is completely cool to the touch.
Connect the flute of the Crease Attachment to the pegs at the bottom of the •
Steam Head.
Push the Crease Attachment into place gently until it clicks. •
To use, place the fabric between the Steam Head and the Crease Attachment to •
create the crease. Move the Steam Head in a vertical motion to press the crease.
ON
OFF
ON
OFF
Fabric Brush Assembly and Use
Turn the steamer off and wait until there is no steam coming from the Steam •
Head and it is completely cool to the touch.
Insert the pegs on the Fabric Brush into the holes in the Steam Head. •
Steam as usual, using the Fabric Brush to smooth stubborn wrinkles. •
wARNINg:
ALWAyS HANG THE STEAM HEAD ON THE STEAM HEAD HANGER WHEN
NOT IN USE TO PREVENT INjURy AND SURFACE DAMAGE.
MAKE SURE THE TELESCOPIC POLE IS FULLy ExTENDED DURING USE TO
ENSURE A SMOOTH STEAM FLOW THROUGH THE HOSE.
DO NOT PULL THE HOSE WITH ExCESSIVE FORCE OR MOVE IT By PULLING
ON THE HOSE. DAMAGE OR INjURy MAy RESULT.
5738-SVP_InstructionSWP3.indd 4-5 4/21/10 4:18:54 PM