SINGER ESP18 ELECTRONIC STEAM PRESS User Manual
Page 9
7
Using the Pressing Cushion
1. For garments constructed with details such
as darts, curved seams, and shoulder pads, a
Pressing Cushion may be used.
2. Use the cushion in areas where no creases are
desired or to shape a tailored garment.
3. Place the area to be pressed onto the Ironing
Board.
4. Place the Pressing Cushion under the dart, seam,
etc.
5. Making sure that the area to be pressed is raised,
lower the Pressing Plate until it meets the raised area.
6. Do not force the plate to its lowest position, as this may cause damage to the unit.
CLEANING THE STEAM PRESS & STORAGE
CLEANING THE STEAM PRESS
1. Place the Pressing Cushion in the middle of
Ironing Board.
2. Place a clean towel over the Pressing Cushion
and the Ironing Board.
3. Set the temperature control Button to its highest
setting(LINEN).
4. When the Steam Burst Ready Indicator Light
illuminates, lower Pressing Plate onto the Pressing
Cushion.
5. Press the Steam Burst Button six times.
6. Allow the Pressing Plate to cool.
7. Clean the Pressing Plate with a damp cloth.
8. Do not use abrasives or you may damage the plate.
9. The Ironing Board cover is removable for cleaning. Hand wash only with mild
detergent.
STORAGE
1. Once pressing is complete, immediately turn unit off and unplug power cord from
electrical outlet.
2. Allow unit to cool completely(at least 30 minutes).
3. Lower Pressing Plate down; and turn Locking Knob to “Lock”position.
4. Wrap up power cord and place in Cord Storage Compartment.
5. Store all accessories safely away, preferably near Digital Fabric Steam Press.
6. Store Digital Fabric Steam Press in a cool, dry place.
7. For long-term of storage, press the Steam Burst Button time to time, to use up the
water remain in the Water Reservoir.
ENG
ESP18_Instruction Manual_US.indd 7
10/11/2012 6:08:55 PM