Sage Control Grip All In One BSB530UK User Manual
Page 11
10
aSSEmBly & oPEratIon
4.
Place the blending leg as deeply as
possible into the bowl and press the
trigger switch to turn the stick mixer
on. The button must be held for the
required duration of operation.
5.
Work through the ingredients in
the bowl with a gentle raising and
lowering motion.
6.
Switch off the motor by releasing the
trigger switch.
7.
Ensure the motor has completely
stopped before lifting the blender
out of the bowl.
8.
When processing has finished,
switch off at the power outlet and
remove the power plug.
to dEtaCH tHE BlEndIng lEg
Ensure the trigger switch is released, the
power is turned off at power point and the
appliance is unplugged. Hold the motor
body with one hand, and using thumb and
finger of the other hand, press on the two
EJECT buttons on either side of the motor
body. Pull the motor body away from the
blending leg to detach.
rECommEndatIonS WHEn USIng
aS a StICK mIxEr
•
The stick mixer blends foods and
liquids rapidly, therefore it is easy to
over process. Remember when using the
blending leg to stop the stick mixer and
check food throughout the operation.
•
Use caution when blending hot food as it
can splatter.
•
The stainless steel blending leg allows
for hot food to be processed directly
in the saucepan. This makes blending
soups and sauces very easy.
•
For safety reasons remove saucepan
away from the heat before processing.
•
Ensure the body of the appliance and
power cord are kept away from any
heat source.
•
When pureeing and blending, cut food
into uniform sizes. This will ensure
smooth and consistent results.
•
Warm all liquids to be added to
soups and purees, this will ensure
even blending.
•
Do not operate the appliance
continuously for more than 1 minute.
Allow the motor to rest for 1 minute
between each use.
If food becomes lodged around the
processing blade or in the blade guard,
follow the safety instructions below:
1.
Release the trigger switch, the power
off at the power outlet and unplug
the cord.
2.
Use a spatula to carefully dislodge
the food. Do not use fingers as the
blades are sharp.
3.
After the food has been removed and
blades are clear, plug the appliance
back into the power supply, switch
the power on and continue blending.