Sage Smart Toast BTA820UK/BTA840UK - Manual (Page 13)

12
PAge heAder..... oPerATIng yoUr neW APPlIAnCe
4. Once the toasting cycle has finished
and the carriage has risen and locked
into the raised position, the toast
ready alert will sound. Remove the
toast. The TOAST/CANCEL button
surround will re-illuminate in white
for up to 30 seconds, ready for the
next toasting cycle.
noTe
The A BIT MORE ™ button can be
used with the TOAST, CRUMPET and
DEFROST functions.
CrUmPeT BUTTon
This feature activates additional heat to
the middle heating elements to perfectly
toast crumpet tops and lightly toast the
crumpet bases.
To toast crumpets:
1. Place the crumpets into the toasting
slots with crumpet tops facing inwards
as per the crumpet markings on the top
cover plate above the middle elements
of the toaster.
2. Select the desired browning setting
by adjusting the browning control
slide on the front of the toaster. The
browning settings range from '1'
(lightest) to '5' (darkest).
3. Press the TOAST/CANCEL button
and the surround will illuminate in
red then press the CRUMPET button
and the surround will illuminate
in white. The crumpets will
automatically lower into the toasting
slots. The middle and side heating
elements will automatically adjust.
4. The QUICK LOOK™ button
surround will also illuminate in white
allowing the toasting progress to
be checked and, if necessary, cancel
the cycle by pressing the TOAST/
CANCEL button when the desired
toast colour is achieved.
5. Approximately 10 seconds before
the end of the selected browning
setting, the QUICK LOOK™ button
will cease illumination. As the
toasting stops and the carriage
rises, the TOAST/CANCEL button
surround will flash and the LED
toasting progress indicator will
cease flashing. The LED
toasting progress indicator will
re-illuminate to the previously
selected browning setting.
6. Once the toasting cycle has finished
and the carriage has risen and
locked into the raised position,
the toast ready alert will sound.
Remove the crumpets. The TOAST/
CANCEL button surround will
re-illuminate in white for up to 30
seconds, ready for the next toasting
cycle. The CRUMPET button
surround will remain illuminated
and should be pressed once to cancel
if a subsequent toasting function
is required. The CRUMPET button
surround will cease to illuminate
after 30 seconds or when the
appliance is switched off at the
power point.
noTe
Place the crumpets into the toasting
slots with crumpet tops facing
inwards as per the crumpet markings
on the top cover plate above the
middle elements of the toaster.