QOMO QD3800 User Manual

Page 19

1) ． Select “Baud rate” and “parity” and input the projector control code.

(The baud rate, parity and control code is supplied by projector’s

manufacturer, please refer to the projector’ manual)

The input format of projector’s control code is as follows:

a. If the data is in the numerical value format, please input data directly,

block them off with comma, do not distinguish lowercase and uppercase.

For example: the “POWER ON” code in Hitachi projector manual is :

BE EF

BA D2

In the POWRE ON box,Input : be, ef, 03, 06, 00, ba, d2, 01, 00, 00, 60, 01,

00. Then use the same input rule to input other code.

b. If the data is in the character string format, input ‘character string’.

For example: the “POWER ON” code in the SHARP C40/50 projector

manual is :

（ “-“ is space，

is enter.）

In the POWER ON box, input ’POWR

1’, 0d, 0a

(Remarks: There are 3 spaces after POWER, 0d, 0a is enter.)

Input other codes in the same way.

c. If the data is in the numerical value and character format, then

synthesize the above-mentioned formats.

3)．Once done, click “Add” to add your projector model, then Click “Send”.

Afterward, click “Ok”. Now, you can use the visualizer to control your

projector.