Power Plate pro7HC - Manual (Page 6)

En
gl
ish
proMOTION ™ Dynamic Vibration
Technology
How Does it Work?
proMOTION™ Dynamic Vibration
Technology uses high strength Vectran
®
cables, which have been specifically
chosen for their unique ability to optimize
the transfer of vibrations generated by the
platform directly to the targeted muscle
Specifically upper body muscles. The
Vectran cables, which pound-by-pound
are five times stronger than steel, transfer
vibration to the upper body at high-
speed frequency rates between 25 and 50
times per second. Vectran
® is a registered
trademark of Hoechst Celanese Corp
Each cable extends to more than two
meters, allowing for movement in all
planes and directions, so you can enjoy full
range of movement and infinite dynamic
exercise options. WARNING: Do not extend
the cables more than 215 cm/84.64 inches
(passed the colored line). Doing so will
void your warranty.
Not only does the proMOTION optimize
the transmission of vibrations to the
targeted muscle but it also offers variable
resistance. Changing the resistance puts
more load on the muscles during the
most intense part of the movement,
offering another way to progress your
The cable resistance of UBD can select from the exercise menu
workouts by increasing the intensity of
your training. The unique gel dampening
system also increases the resistance
as you work harder.
Usage and Guidelines
As with any form of exercise, cease your
session immediately if you feel faint, dizzy
or ill while working out on the Power
Plate
® machine. Always consult a doctor or
specialist before restarting your training.
As with any training routine, it is important
to start using the proMOTION on the
lowest level of resistance and with the
Power Plate machine on a low setting.
Establish a good technique before
increasing the setting on the proMOTION
from low to high.
Always pay special attention to your
posture, especially the position of your
wrists and back, and how close you are
to the Power Plate machine. proMOTION
cables should be used within the normal
range and angle to maximize training
effect and prevent damaging the device.
The cables should be used between
90 degrees and 25 degrees from the
horizontal base.
10
Guidance and manufacture’s declaration – electromagnetic emissions-
for all ME EQUIPMENT and ME SYSTEMS
Guidance and manufacture’s declaration – electromagnetic emission
The Pro7HC is intended for use in the electromagnetic environment specified below. The customer of the
user of the Pro7HC should assure that it is used in such an environment.
Emission test Compliance Electromagnetic environment – guidance
Group 1 The Pro7HC use RF energy only for its internal function.
Therefore, its RF emissions are very low and are not
likely to cause any interfe rence in nearby electronic
equipment.
RF emission CISPR 11 Class B Class A with IEC61000-3-2
Complies with IEC61000-3-3
Harmonic emissions Class A The Pro7HC is suitable for use in all establishments,
IEC 61000-3-2 including domestic establishments and those directly
connected to the public low-voltage power supply
Voltage fluctuations/ Comply network that supplies buildings used for domestic
flicker emissions purposes.
IEC 61000-3-3
Wi-Fi Specifications Network Standard: IEEE 802.11b/g/n
Band: 2.400-2.4835GHz
Cover Range: 20meter
Wi-Fi Power: 10dBm
EMC Declaration
12