Origin Live All MK3 Decks - Manual (Page 9)

Page 9
R E P A C K I N G M E T H O D - Please read carefully and pack exactly as instructions show.
Wrap platter and platter mat in
polythene bag before placing in
foam cut out
Instruction manual
AVOID LOADING THIS AREA as it can stress the
armboard of the sub-chassis underneath. The
only exception to this is if an arm is included or
empty box - larger arms will not fit - i.e Encounter
and above
Wrap motor pod in polythene bag then tape ( or rubber
band) round the cardboard tube which has a slit in it’s side
- the tube sits on top of the base plate, not round it. This is
to provide protection against anything that might knock
the end of the motor shaft as this can cause damage. Note
that the motor pod must be positioned in this corner of the
box where there is the greatest depth i.e not over the plinth
armboard
Place the strobe card and belt in the top of the motor pod
card tube.
Place the wall wart transformer
here and then place the bubble bag
containing the following items on top of
the transformer
Bag contains - Cork washer for arm,
Oil bottle, screw driver, 3mm & 2.5mm
allen key
ELASTIC BANDS round split cardboard
tube which must sit on top of motor pod
base flange.
BELT & STROBE CARD PLACED IN MOTOR POD
PACKING
The belt needs to be rolled into a spiral and
placed in a small polythene bag - if loose
packed the belt can get crushed on bends and
permentantly deformed.
PLACE RUBBER BUNG IN TOP OF BEARING HOUSE
WRAP PLINTH IN POLYTHENE BAG BEFORE LOWERING
INTO BOX WRAP SPINDLE HUB IN POLYTHENE AND
PLACE IN FOAM HOLE SHOWN
VERY IMPORTANT - This card and foam
peice must be placed here as shown to
protect platter and ensure no damage
to sub-chasses