Modern AG 8' Predator - Manual (Page 45)

MaInTEnancE SEcTIon
DRIVELInE LUBRIcaTIon
Grease Fittings are located on the Cross assembly of each u-Joint and on the telescoping tubes.
Grease the u-Joint after each 8 hours of use. Do not force grease through the needle Cup assemblies.
Grease the telescoping tubes after every 8 hours use. Some PtO-to-Hitch connections may necessitate
cutting a hole in the shields to be able to align the Grease Fitting holes for lubrication. Lubricate the
shield bearings every 40 hours.
make certain that the Driveline Integral Shields are free to telescope and rotate around the
Driveline without binding.
LIFT TyPE DRIVELInE & PULL JacKSHaFT SHIELDS
to remove the main inner driveline shield, Remove the locking screws. align the bearing tabs with
the cone pockets. Remove the half-guard and remove the bearing ring.
Inspect the driveline shield for worn areas or cracks. If the shield has any dents or cracks, replace
the Shield. While the Shields are off, examine the Driveline for signs of abnormal wear, bent or
twisted shafts, or cracks in the shafts or tubes. Check to see that the Drivelines telescope easily. If the
Drivelines do not telescope properly or show signs of abnormal wear, the shaft should be repaired
or replaced.
caUTIon
8' Predatorrr - 45