beautypg.com

Releasing seat belts, Locking, Releasing seat belts locking – Mercedes-Benz R-Class 2006 Owners Manual User Manual

Page 68

background image

67

Getting started

Parking and locking

Releasing seat belts

̈

Press the seat belt release button
(

page 51).

Allow the retractor to completely re-
wind the seat belt by guiding the latch
plate.

Locking

̈

Exit the vehicle and close all doors and
the tailgate.

!

Make sure the seat belt retracts fully so
that the seat belt and/or latch plate
cannot get caught or pinched in the
door or in the seat mechanism. This
can damage the seat belt and impair
the effectiveness of the seat belt,
and/or cause damage to the door
and/or door trim panel. Such damage
is not covered by the Mercedes-Benz
Limited Warranty.

Damaged seat belts must be replaced.
Contact an authorized Mercedes-Benz
Light Truck Center.

Warning!

G

To prevent possible personal injury, always

keep hands and fingers away from the door

openings when closing the doors. Be espe-

cially careful when small children are

around.

Before closing doors, make sure there is no

possibility of someone getting caught in a

door during closing.

Warning!

G

When leaving the vehicle, always remove the

SmartKey from the starter switch, take the

SmartKey with KEYLESS-GO* with you, and

lock your vehicle. Do not leave children un-

attended in the vehicle, or with access to an

unlocked vehicle. Unsupervised use of vehi-

cle equipment may cause an accident

and/or serious personal injury.

i

A warning sounds and the message

Switch off lights

appears in the

multifunction display if the vehicle’s
exterior lamps are not switched off

ț

with the SmartKey removed from
the starter switch and the driver’s
door open

ț

with the engine turned off using the
KEYLESS-GO* start/stop button
and the driver’s door open (same as
SmartKey removed from starter
switch)

Switch off the exterior lamps.