La-Z-Boy Luxury-Lift Power Recliner - Manual (Page 6)

F IGURE 13
F IGURE 12 F IGURE 11
Power Transformer Connection Inner Body
Back Panel Back
Upholstery Cover
Luxury-Lift ® Power Recliner
Assembly Instructions
Luxury-Lift ® Power Recliner
Assembly Instructions
11 10
(1ML shown) (1ML shown)
(1ML shown)
– To reduce the risk of serious injury:
• Check the condition of the power transformers, electrical cords, plugs, and connectors
monthly. Keep the power transformers and electrical cords away from heat sources. Never
operate the unit with a damaged power transformer, electrical cord, plug, or connector.
Contact your La-Z-Boy
® dealer for service.
WARNING
12. Connect the Power Transformer connectors.
• Remove the Power Transformer from the box and unwind the cord.
• Align the clips on the power transformer connector and the connector behind the chair
and push the connectors together until they lock (F
IGURE 11).
– To reduce the risk of serious injury or death:
• Plug directly into a wall outlet. Do not use an extension cord, adapter or surge protector.
DANGER
13. The automatic homing feature returns the lift chair to the seated position after power is restored
following a power interruption. This feature may cause the lift chair to move slightly when plugged in.
Plug the Power Transformer directly into a wall outlet.
14. Retrieve the hand wand from the pocket. Stand beside the chair and press the toggle lever on the
hand wand toward the UP position. Raise the lift chair until the inner body back panel is slightly
above the outer body back panel (F
IGURE 12).
15. Locate the fastening tape on the back upholstery cover and the fastening tape on the inner body
back panel (F IGURE 12).
• Pull the back upholstery cover down tight. Firmly press the fastening tape on the back upholstery
cover to the fastening tape on the inner body back panel (F IGURE 13).
• Press the toggle lever on the hand wand toward the DOWN position to lower the lift chair.
16. Proceed to the Battery Backup Assembly Instructions.
NOTICE: To prevent product damage operate this chair only when
it is upright, setting on its base.
NOTICE: To prevent damage to the connectors and cords, it is important
to unfasten all connections prior to removing the back.
17. To remove the back, unplug the Power Transformer from the electrical outlet and disconnect the
Power Transformer connection at the base of the chair. Reverse the Assembly Instructions steps.