La-Z-Boy La-Z-Touch Massage System 11/27/2011-01/01/2013 - Manual (Page 4)

7 6
NOTICE:
Do not plug the transformer in until instructed.
1. The power transformer is secured to the seat swing. Carefully cut the cable tie and set
the power transformer aside.
2. Install the back.
• Lay the back across the chair arms. Lift the back at a slight angle and align the brackets
on the back with the brackets on the body (F
IGURE 1).
• Lower the back onto the body, making sure the back and body brackets are completely engaged.
- To make sure the back is properly installed, with both sets of back and body brackets
engaged, stand behind the chair and twist the back from side to side. If one or both sides
move out of position, the brackets are not engaged (F
IGURE 2). Remove the back and
repeat the steps above.
- If you are unable to install the back properly, contact your La-Z-Boy dealer for assistance.
• Lock the brackets by using a screwdriver to push down the locking levers (F IGURE 3).
3. To access the connectors, gently roll the chair forward to rest on the arms and the top of
the back. The connectors are located at the back of the chair, under the rear seat (F IGURE 4).
4. Identify the three electrical connectors.
• The two larger, round connectors are for the hand wand connection (F IGURE 5).
• The smaller, round connector is for the power transformer connection (F IGURE 5).
La-Z-Touch ® 2-Motor Massage & Heat Recliner
Assembly Instructions:
– To reduce the risk of injury:
• Do not operate the unit until the back is installed and locked.
WARNING
(Assembly Instructions Continued)
F IGURE 4 F IGURE 3
F IGURE 5
Hand Wand
Connectors
Body
Bracket
Back Bracket
Back and body brackets on this side
are not engaged. Remove the back
and reinstall.
Back
Bracket
Locking
Lever
Locking
Position
La-Z-Touch ® 2-Motor Massage & Heat Recliner
Assembly Instructions:
F IGURE 1 F IGURE 2
Left Side (Sitting) Rear Seat
Outside Back
Power Transformer
Connector