Kontron pITX-SP - Manual (Page 7)

KTD-S0003-C Page 3 BIOS Update
p ITX-SP Software Guide
2 BIOS Update
The AMI and the KONTRON update tool is available for two operating systems: DOS and Windows ® (e.g.
Windows ® XP, Vista 32/64 or Windows ® 7).
Software conditions:
Operating System Tool Name Required Revision
AFUDOS.EXE 4.23 or greater
DOS
BF.EXE 7.41 or greater
AFUWIN.EXE + UCORESYS.SYS (UCOREW64.SYS) 4.41 or greater
Windows ®
BF.EXE 7.41 or greater
2.1 AFUDOS (AMI)
Only the following combination of command line arguments has been tested and should be used for the
update process. The syntax of the DOS update tool is:
AFUDOS /X /P /B /N /C
/X = don't check ROM ID
/P = program main BIOS
/B = program boot block
/N = overwrite NVRAM (setup settings)
/C = destroy CMOS checksum
2.2 AFUWIN (AMI)
For 32bit operating systems the file UCORESYS.SYS and for 64bit systems the file UCOREW64.SYS must be
used (located in the same folder as AFUWIN.EXE). AFUWIN can either be executed using the same command
line parameters as for AFUDOS or it can be executed in GUI mode by double klicking on it.
2.3 BFLASH (KONTRON)
In this manual the abbreviation BF is used for BFlash. This also matches with the actual name of the tool
(BF.EXE). BF can be used to read and write data to and from BIOS flash. With this tool it's possible to
update the BIOS, change DMI codes, setup vendor codes and save copies of all data. The copies can be used
as master data for mass production.
Type
BF from DOS prompt to see the BFlash version number and the board version. Only the following
combination of command line arguments has been tested and should be used for the update process.
BF read 0 100000
BF write 0