Kontron CPCI - Manual (Page 11)

CPCI Power Supply Preface
ID 24139, Rev. 06 Page xi
For Your Safety
Your new Kontron product was developed and tested carefully to provide all features necessary
to ensure its compliance with electrical safety requirements. It was also designed for a long
fault-free life. However, the life expectancy of your product can be drastically reduced by im-
proper treatment during unpacking and installation. Therefore, in the interest of your own safety
and of the correct operation of your new Kontron product, you are requested to conform with
the following guidelines.
Temperature and High Voltage Safety Instructions
Special Handling and Unpacking Instructions
• Do not handle this product out of its protective enclosure while it is not used for opera-
tional purposes unless it is otherwise protected.
• Whenever possible, unpack or pack this product only at EOS/ESD safe work stations.
Where a safe work station is not guaranteed, it is important for the user to be electrically
discharged before touching the product with his/her hands or tools. This is most easily
done by touching a metal part of your system housing.
• It is particularly important to observe standard anti-static precautions when changing pig-
gybacks, ROM devices, jumper settings etc. If the product contains batteries for RTC or
memory backup, ensure that the board is not placed on conductive surfaces, including
anti-static plastics or sponges. They can cause short circuits and damage the batteries
or conductive circuits on the board.
Warning!
All operations on this device must be carried out by sufficiently skilled
personnel only.
Be careful, this device will heatup during operation, and if touched
may cause burns. Allow for sufficient cool down before handling after
power is turned off.
Caution, Electric Shock!
Before installing your new Kontron product into a system always
ensure that your mains power is switched off. This applies also to the
installation of piggybacks.
Serious electrical shock hazards can exist during all installation,
repair and maintenance operations with this product. Therefore,
always unplug the power cable and any other cables which provide
external voltages before performing work.
ESD Sensitive Device!
Electronic boards and their components are sensitive to static elec-
tricity. Therefore, care must be taken during all handling operations
and inspections of this product, in order to ensure product integrity at
all times.