Kontron AM5020 IPMI Firmware - Manual (Page 40)

IPMI Firmware AM5020
Page 32 ID 1045-0205, Rev. 1.0
P R E L I M I N A R Y
6.2 FRU Data Update
Update of the FRU data can be done via regular IPMI FRU device commands. The correct FRU
data must be prepared at the factory.
7. E-Keying
E-Keying has been defined in the AMC.0 R2.0 Specification to prevent module damage,
prevent malfunction, and verify bay connection compatibility. Therefore, the FRU data of an
AMC module contains PICMG-defined records which describe the module’s AMC
interoperability:
• Module Current Requirements Record
• Clock Configuration Record, for the PCI Express reference clock
• AMC Point-to-point Record, describing module’s AMC port capabilities
The IPMI commands Set AMC Port State and Get AMC Port State defined by the
AMC.0 specification are used by the carrier or MCH for either granting or rejecting the E-keys
(i.e. enabling or disabling of AMC ports during E-Keying).
Which AMC port connections are activated will be decided during E-keying. The information
which AMC port is enabled or not, can be directly read from the board’s E-Keying
configuration registers (IAKEY0 and IAKEY1) at addresses 0x298 / 0x299.
The DIP Switch SW3 can be used to forcibly disable some AMC ports if required. Please refer
to the AM5020 User Guide for details.
7.1 PCI Express Lane Width – x4 or x1
The AM5020 supports either two PCI-E x4 connections (default) or up to eight PCI-E x1
connections.
The required PCI Express lane width (x4 or x1) must configured using the kpci uEFI Shell
command.
For further information, refer to the AM5020 uEFI BIOS User Guide, Chapter 6, uEFI Shell.
7.2 PCI Express Reference Clock
Both sides (Root Complex and Endpoint) of a PCI Express connection should be driven by a
common reference clock. The PCI Express reference clock may be generated locally by the
module or acquired from the AMC connector.
The AM5020 (PCI Express Root Complex) may act either as clock receiver or as clock
source. This is described by the Clock Configuration Record (for the PCI Express reference
clock) and defined by the “AMC.1 R2.0, PCI Express on AMC” specification.
The DIP Switch SW3 can be used to overwrite the clock configuration (clock receiver, clock
source, etc.) regardless of the E-keying results. Please refer to the AM5020 User Guide for de-
tails.