Kontron CP-RIO6-A216 - Manual (Page 27)

CP-RIO6-Ax/Bx Introduction
ID 1030-8996, Rev. 2.0 Page 1 - 13
P R E L I M I N A R Y
1.5 Standards
The CP-RIO6-Ax/Bx complies with the requirements of the following standards:
Table 1-3: Standards for the CP-RIO6-Ax/Bx
TYPE ASPECT STANDARD REMARKS
CE Emission EN55022
EN61000-6-3 --
Immission EN55024
EN61000-6-2 --
Electrical Safety EN60950-1 --
Mechanical Mechanical Dimen-
sions IEEE 1101.10 --
Environmental Climatic Humidity IEC60068-2-78 93% RH at 40°C, non-condensing
WEEE Directive 2002/96/EC Waste electrical and electronic equipment
RoHS Directive 2002/95/EC Restriction of the use of certain hazardous
substances in electrical and electronic
equipment
Vibration
(Sinusoidal) IEC61131-2
IEC60068-2-6 Test parameters:
• 5-150 (Hz) frequency range
• 1 (g) acceleration
• 1 (oct/min) sweep rate
• 10 cycles/axis
• 3 axes
Single Shock IEC61131-2
IEC60068-2-27 Test parameters:
• 15 (g) acceleration
• 11 (ms) pulse duration
• 3 shocks per direction
• 6 directions
• 5 (s) recovery time
Note ...
Kontron performs comprehensive environmental testing of its products in accor-
dance with applicable standards.
Customers desiring to perform further environmental testing of Kontron prod-
ucts must contact Kontron for assistance prior to performing any such testing.
This is necessary, as it is possible that environmental testing can be destructive
when not performed in accordance with the applicable specifications.
In particular, for example, boards without conformal coating must not be
exposed to a change of temperature exceeding 1K/minute, averaged over a
period of not more than five minutes. Otherwise, condensation may cause irre-
versible damage, especially when the board is powered up again.
Kontron does not accept any responsibility for damage to products resulting
from destructive environmental testing.