Koala Kare 208-KIT - Manual

Materials Supplied:
Two 3/8” Phillips Panhead Machine Screws
One Strap
Tools Required:
Phillips Head Screwdriver
1. Use a Phillips Head Screwdriver to remove
the screws securing the old strap. Discard the
old strap and screws.
2. Take the new strap and lay it on the unit.
Position the strap so that the short end of the
strap is towards the back of the unit.
3. Secure the strap to the unit by inserting
one of the screws provided through the hole
in the chafe tab and into the insert in the front
of the unit.
4. Repeat the previous step for the opposite
end of the strap.
5. Clean up work area and close unit.
KB208 REPLACEMENT STRAP INSTRUCTIONS
P/N 208-KIT
Koala Kare Products ǁ 6982 S Quentin St. ǁ Centennial, CO 80112 Toll Free: 888.733.3456 ǁ 303.539.8300 ǁ Fax: 303.539.8399
www.koalabear.com
®
P/N 1031 March 2013