Karcepts KFSB-AP-XX - Manual (Page 8)

3. Quick Adjustment Setup (continued...)
B.
Install the male half of endlinks into Hole #4 of each sway bar arm and secure
with the 3/8" flange nuts. Proper torque on this nut is 28 ft-lbs, but since this is
the adjustment nut, it's impractical to assume you'll be using a torque wrench
every time you make a sway bar change. Just tighten by feel approximately
close to 28 ft-lbs. Plan to use a 9/16" ratcheting combination wrench on this nut
for quickest adjustments. Install female half of endlinks into the OEM sway bar
endlink locations on the lower control arms. Use a 1/2" open end wrench (to
hold the endlink stud from spinning) along with a 9/16" socket to secure the
provided 3/8" nylon-insert locknuts, and torque to 28 ft-lbs.
Male half of endlink Female half of endlink
3/8" nylon-insert locknut 3/8" flange nut (adjustment nut)