Sway bar arm installation – Karcepts KFSB-AP-XX User Manual
Page 6
2. Sway Bar Arm Installation
A.
Slide the left sway bar arm over the splined end of the center section, leaving
1/16" of shaft protruding past the end of the arm. This is the optimal arm
installation position. Thread the M12x50 socket head cap screw through the
arm; and with a 10mm hex bit socket, torque to 50 ft-lbs.
B.
Repeat the above for the right sway bar arm, making certain to clock the right
arm onto the shaft splines to an exact mirror image as the left arm.
Arms clocked properly
Arms clocked incorrectly (off one tooth)