Chicago Electric 39954 - Manual (Page 3)

Page 3 SKU 39954 For technical questions, please call 1-800-444-3353.
Avoid electrical shock. 9. Use extreme caution when clamping around uninsulated conduc-
tors or bus bars. Prevent body contact with grounded surfaces such as pipes, radiators,
ranges, and cabinet enclosures when testing voltages.
Keep work area clean
10. . Cluttered areas invite injuries.
Avoid damaging Jumpstarter System 11. . Use only as specified in this manual.
Observe work area conditions 12. . Do not use tool in damp or wet locations. Don’t expose
to rain. Keep work area well lighted.
Keep children away
13. . Children must never be allowed in the work area. Do not let them
handle machines, tools, or extension cords.
Store idle equipment
14. . When not in use, tools must be stored in a dry location to inhibit
rust. Always lock up tools and keep out of reach of children.
do not place this unit
15. in direct sunlight, direct heat or moisture.
dress properly 16. . Do not wear loose clothing or jewelry as they can be caught in moving
parts. Protective, electrically nonconductive clothes and nonskid footwear are recom-
mended when working. Wear restrictive hair covering to contain long hair.
Use eye and ear protection
17. . Always wear ANSI-approved impact safety goggles.
do not overreach 18. . Keep proper footing and balance at all times. Do not reach over or
across electrical cables or frames.
Maintain tools with care
19. . Inspect tool cords periodically and, if damaged, have them
repaired by an authorized technician.
Stay alert
20. . Watch what you are doing, use common sense. Do not operate any tool
when you are tired.
Check for damaged parts
21. . Before using any tool, any part that appears damaged
should be carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment and binding of moving parts; any broken parts
or mounting fixtures; and any other condition that may affect proper operation. Any part
that is damaged should be properly repaired or replaced by a qualified technician. Do
not use the tool if any switch does not turn On and Off properly.
Replacement parts and accessories
22. . When servicing, use only identical replacement
parts. Use of any other parts will void the warranty. Only use accessories intended for
use with this tool. Approved accessories are available from Harbor Freight Tools.
Do not operate tool if under the influence of alcohol or drugs
23. . Read warning labels
on prescriptions to determine if your judgment or reflexes are impaired while taking drugs.
If there is any doubt, do not operate the tool.
People with pacemakers should consult their physician(s) before use. Electromag-
24.
netic fields in close proximity to heart pacemaker could cause pacemaker interference
or pacemaker failure.
The warnings, cautions, and instructions discussed in this instruction manual cannot
25.
cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built into this
product, but must be supplied by the operator.