Specifications, Save this manual, Safety warnings and precautions – Chicago Electric 39954 User Manual
Page 2: Read all instructions before using this tool

Page 2
SKU 39954
For technical questions, please call 1-800-444-3353.
REV 08b, 08k
SPECiFiCATiOnS
Battery Type
Sealed, lead-acid, rechargeable, 17 Ah
Power Output
12 VDC, 900 amps peak; 400 amps starting power
Cables
Rubber insulated (#4) copper; 400 amp clamps
Compressor
260 PSI maximum pressure
Output Socket
12 VDC Cigarette lighter output
Features
Overload protection
•
Automatic charge cutoff (at 14.5~15.5 volts) to help
•
prevent overcharging
Inflating Needle and Air Raft Tips
•
note: Performance of this unit may vary depending on variations in local line voltage.
Save This Manual
You will need the manual for the safety warnings and precautions, assembly instructions,
operating and maintenance procedures, parts list and diagram. Keep your invoice with this
manual. Write the invoice number on the inside of the front cover. Keep the manual and
invoice in a safe and dry place for future reference.
SAFETy WARningS And PRECAUTiOnS
WARNING:
When using tool, basic safety precautions should always be followed to reduce
the risk of personal injury and damage to equipment.
Read all instructions before using this tool!
Wear eye protection.
1.
When working on or around lead-acid batteries, always wear
ANSI-approved eye protection.
Avoid contact with Battery Acid.
2.
If splashed, immediately wash effected area with
clean water. Continue washing area until medical help arrives.
Connect cables to proper polarities.
3.
Connect RED POSITIVE (+) cable to Positive
Battery Terminal first. Connect BLACK NEGATIVE (-) cable to body ground (a non moving
metal part) second.
do not connect the BlACK nEgATiVE (-) cable to the negative
Battery Terminal. Turn vehicle ignition off before making cable connections.
Use this tool in well ventilated areas.
4.
Do not attempt to jump start vehicle around
flammable gases or liquids.
do not allow the Black and Red clamps to touch.
5.
If this happens it can melt clamps
or other metal objects. Place them only on the corresponding terminals.
12 Volt Systems Only.
6.
Use only with vehicles and boats with 12 volt electrical sys-
tems.
For emergency use only.
7.
Do not use this system in the place of a vehicle battery. Only
use to jump start your vehicle.
Avoid working alone
8.
. If an accident happens, an assistant can bring help.