Jeep 2015 Compass - User Guide - Manual (Page 67)

NOTE:
The mobile phone may require authorization prior to download.
• A maximum of 1,000 entries per phone will be downloaded and updated every
time a phone is connected to the Uconnect ® Phone.
• Depending on the maximum number of entries downloaded, there may be a short
delay before the latest downloaded names can be used. Until then, if available, the
previously downloaded phonebook is available for use.
• Only the phonebook of the currently connected mobile phone is accessible.
• Only the mobile phone’s phonebook is downloaded. The SIM card phonebook is
not part of the Mobile phonebook.
• This downloaded phonebook cannot be edited or deleted on the Uconnect ®
Phone. These can only be edited on the mobile phone. The changes are transferred
and updated to Uconnect
® Phone on the next phone connection.
Making A Phone Call
• Push the “Phone” button .
• After the BEEP, say “dial” (or “call” a name).
• After the BEEP, say number (or name).
Receiving A Call — Accept (And End)
• When an incoming call rings/is announced on Uconnect ® , push the “Phone”
button .
• To end a call, push the “Phone” button .
Mute (Or Unmute) Microphone During Call
• During a call, push the “Voice Command” button .
• After the BEEP, say “mute” (or “mute off”).
Transfer Ongoing Call Between Handset And Vehicle
• During a call, push the “Voice Command” button .
• After the BEEP, say “transfer call.”
Changing The Volume
• Start a dialogue by pushing the “Phone” button , then adjust the volume
during a normal call.
• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable
level while the Uconnect ® system is speaking. Please note the volume setting for
Uconnect ® is different than the audio system.
ELECTRONICS
65