beautypg.com

Parkview® rear back-up camera, Continuously variable automatic transmission (cvt), Six-speed automatic transmission – Jeep 2015 Compass - User Guide User Manual

Page 33: Parkview, Rear back-up camera, Continuously variable automatic, Transmission (cvt), Six-speed automatic, Transmission, Operating your vehicle

background image

PARKVIEW® REAR BACK-UP CAMERA

You can see an on-screen image of the rear of your vehicle whenever the shift lever is
put into REVERSE. The ParkView

®

Rear Back-Up Camera image will be displayed on

the radio display screen, located on the center stack of the instrument panel.

If the radio display screen appears foggy, clean the camera lens located on the
liftgate.

Refer to your Owner's Manual on the DVD for further details.

WARNING!

Drivers must be careful when backing up; even when using the ParkView

®

Rear

Back-Up Camera. Always check carefully behind your vehicle, and be sure to
check for pedestrians, animals, other vehicles, obstructions, or blind spots before
backing up. You must continue to pay attention while backing up. Failure to do so
can result in serious injury or death.

CONTINUOUSLY VARIABLE AUTOMATIC

TRANSMISSION (CVT)

While conventional automatic transmissions typically have 4, 5 or 6 speeds, the
Continuously Variable Transmission (CVT) has an infinite number of speeds. This
allows it to adjust to exactly the right ratio to optimize performance and fuel
economy.

Under hard acceleration, you may hear more engine noise than with a conventional
transmission. The CVT may also occasionally feel like it is “shifting.” These
characteristics are perfectly normal and contribute to the CVT's efficiency.

SIX-SPEED AUTOMATIC TRANSMISSION

This electronically-controlled transmission provides a precise shift schedule. The
transmission electronics are self-calibrating; therefore, the first few shifts on a new
vehicle may be somewhat abrupt. This is a normal condition, and precision shifts will
develop within a few hundred miles (kilometers).

The transmission shift lever has only PARK, REVERSE, NEUTRAL, and DRIVE shift
positions. Manual shifts can be made using the Autostick

®

shift control. Moving the

shift lever to the left or right (-/+) while in the DRIVE position will manually select the
transmission gear, and will display the current gear in the instrument cluster as 6, 5,
4, 3, 2, 1.

Refer to your Owner’s Manual on the DVD for further information.

OPERATING YOUR VEHICLE

31