Jeep 2014 Cherokee - User Guide - Manual (Page 149)

Oil Life Reset
• Your vehicle is equipped with an engine oil change indicator system. The “Oil
Change Due” message will flash in the EVIC display for approximately 10 seconds
after a single chime has sounded, to indicate the next scheduled oil change
interval. The engine oil change indicator system is duty cycle based, which means
the engine oil change interval may fluctuate, dependent upon your personal
driving style.
• Unless reset, this message will continue to display each time you turn the ignition
switch to the ON/RUN position or cycle the ignition to the ON/RUN position if
equipped with Keyless Enter-N-Go™. To turn off the message temporarily, push
and release the MENU button. To reset the oil change indicator system (after
performing the scheduled maintenance) refer to the following procedure:
Vehicles Equipped With Passive Entry
Without pushing the brake pedal, push the ENGINE START/STOP button and cycle
the ignition to the ON/RUN position (Do not start the engine.)
1. Push the OK button to enter the EVIC menu screen.
2. Push and release the DOWN arrow button to access the ”Oil Life” menu
screen.
3. Push the LEFT arrow button or RIGHT arrow button to access the “OIL
LIFE” submenu.
4. Push the OK button to reset the “OIL LIFE” to 100%
5. Push the UP arrow button to exit the EVIC menu screen
Vehicles Not Equipped With Passive Entry
Without pushing the brake pedal, cycle the ignition to the ON/RUN position (Do not
start the engine.)
1. Push the OK button to enter the EVIC menu screen.
2. Push and release the DOWN arrow button to access the ”Oil Life” menu
screen.
3. Push the LEFT arrow button or RIGHT arrow button to access the “OIL
LIFE” submenu.
4. Push the OK button to reset the “OIL LIFE” to 100%
5. Push the UP arrow button to exit the EVIC menu screen
NOTE:
If the indicator message illuminates when you start the vehicle, the oil change
indicator system did not reset. If necessary, repeat this procedure.
WHAT TO DO IN EMERGENCIES
147