Jeep 2013 Wrangler - Owner Manual - Manual (Page 36)

1. Roll down the glass window to prevent any damage.
2. Remove the hinge pin screws from the upper and lower
outside hinges (using a #T50 Torx® head driver).
NOTE: The hinge pin screws and nuts can be stowed in
the rear cargo tray located under the rear loadfloor.
3. Unplug the wiring harness connector under the instru-
ment panel by pressing the tab at the top of the connector
and pulling to disconnect.
NOTE: If the red latch on the connector is locked, pull the
red latch down. This will unlock the connector tab, allowing
the tab to be pressed down and enabling the harness to be
disconnected.
Door Removal Warning Label
Hinge Pin Screw
34 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE