Jeep 2013 Wrangler - Owner Manual - Manual (Page 298)

3. Attach the front of the side bar to the windshield
frame.
• Install the top two hex bolts (13 mm) first, then the
lower side hex bolt (13 mm). The lower side bolt will
not align until the top two bolts are installed.
4. Tighten all side bar attachment bolts.
5. Install the lower windshield plates with the six black
round-headed Torx® head screws (using a #40 Torx®
head driver) on each side of the base of the wind-
shield.
6. Reinstall the wiper arms.
296 UNDERSTANDING THE FEATURES OF YOUR VEHICLE