Jeep 2013 Grand Cherokee - Owner Manual - Manual (Page 24)

• For vehicles equipped with Keyless Enter-N-Go™,
make sure the vehicle ignition system is
ЉOFFЉ.
• For vehicles not equipped with Keyless Enter-N-Go™,
make sure the vehicle ignition system is
ЉOFFЉ and the
key is physically removed from the ignition.
2. Perform one of the following methods to lock the
vehicle:
• Press LOCK on the interior power door lock switch
with the driver and/or passenger door open.
• Press the LOCK button on the exterior Passive Entry
Door Handle with a valid Key Fob available in the same
exterior zone (refer to
ЉKeyless Enter-N-Go™Љ in ЉThings
To Know Before Starting Your Vehicle
Љ for further infor-
mation).
• Press the LOCK button on the Remote Keyless Entry
(RKE) transmitter.
3. If any doors are open, close them.
To Disarm The System
The Vehicle Security Alarm can be disarmed using any of
the following methods:
• Press the UNLOCK button on the Remote Keyless
Entry (RKE) transmitter.
• Grasp the Passive Entry Unlock Door Handle (if
equipped, refer to ЉKeyless Enter-N-Go™Љ in ЉThings
To Know Before Starting Your Vehicle
Љ for further
information).
• Cycle the vehicle ignition system out of the OFF
position.
• For vehicles equipped with Keyless Enter-N-Go™,
press the Keyless Enter-N-Go™ Start/Stop button
(requires at least one valid Key Fob in the vehicle).
• For vehicles not equipped with Keyless Enter-N-
Go™, insert a valid key into the ignition switch and
turn the key to the ON position.
22 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE