Phone pairing, Making a phone call, Phonebook edit – Jeep 2011 Wrangler - User Guide User Manual

Page 44: Receiving a call – accept (and end), Electronics

• For vehicles equipped with Video Entertainment System (VES)™, refer to the

Uconnect™ Phone section of the Uconnect™ User's Manual on the DVD for further
details.

• For vehicles not equipped with VES™, refer to your vehicle Owner's Manual on the

DVD for further details.

NOTE: The Uconnect™ Phone requires a mobile phone equipped with the Bluetooth

Hands-Free Profile, Version 0.96 or higher. For Uconnect™ customer support, call
1–877–855–8400 or visit www.jeep.com/uconnect.

Phone Pairing

NOTE: Pairing is a one-time initial setup before using the phone. You will also need to
follow the Bluetooth

instructions in your cell phone user guide to complete the phone

pairing setup.

• Press the Phone button

to begin.

• Wait for the “ready” prompt and BEEP.

• (After the BEEP), say “Uconnect setup”.

• (After the BEEP), say “phone pairing”.

• (After the BEEP), say “pair a phone”.

• Follow the audible prompts.

• You will be asked to enter a four-digit Personal Identification Number (PIN), which

you will later need to enter into your mobile phone. You can enter any four-digit PIN.
You will not need to remember this PIN after the initial pairing process.

• You will then be prompted to give the phone pairing a name (each phone paired

should have a unique name).

• Next you will be asked to give this new pairing a priority of 1 thru 7 (up to seven

phones may be paired); 1 is the highest and 7 is the lowest priority. The system will
only connect to the highest priority phone that exists within the proximity of the vehicle.

Making A Phone Call

• Press the Phone button

• (After the BEEP), say “dial” (or “call” a name).

• (After the BEEP), say number (or name).

Phonebook Edit

• Press the Phone button

• (After the BEEP), say “phonebook”.

• (After the BEEP), say “new entry” or “list names” or “delete”.

• Follow the prompts.

Receiving A Call – Accept (And End)

• When an incoming call rings/is announced on Uconnect™, press the Phone

button

• To end a call, press the Phone button

ELECTRONICS